WikiWorks
　

JV-1MD/JV-DV/JV-DVF Installation Manual

JV-DVF

  1. Install the flush mount back box [A] in the wall.

  2. Insert the filled-in nameplate [C].
    Refer to "Filling in the nameplate" for nameplate instructions.

    ATTENTION

    • Do not put a sticker over the nameplate. This will decrease the LED's nighttime illumination.

  3. Connect wires to the station.
    Slide down and then open the terminal cover on the back of the station, and strip 8 mm (5/16") of the wire jacket and insert it into the terminal. If it is difficult to insert, press and hold the release button while inserting.
    Be sure to close the terminal cover, then slide it up.

    ATTENTION

    • Failure to slide up the cover may cause water to enter the terminals, etc., resulting in damage to the station.

  4. Fasten the front panel [B] to the back box [A] with the special screws [D] (×4).
    Use the hexagonal wrench [E] to install.

    ATTENTION

    • Do not install the station with the cables trapped or pressed hard by the main unit.
    • Do not overtighten the screws.
WikiWorks